Single Gen-set Controllers Training (Prague)

Single Gen-set Controllers Training - Simple Controllers and Applications

The course is focused on InteliLite, InteliGen 200, InteliGen 500 controllers. Participants are expected to have basic knowledge of gensets and power distribution systems. No previous knowledge of ComAp products is required.

After finishing this training, you will know which ComAp product to choose for your application, where to get detailed information about using the device and how to configure the controller.

Further to this, you will also gain knowledge of extending controller capabilities using ComAp controller accessories, including information about remote monitoring and control systems.

Basics of complex sites using multiple gensets in an island or parallel to mains operation are explained.

The training contains several practical sessions where you will be working directly with ComAp controllers.

Cost per attendee is 55€ per day.

Training will include:

Preparation

Basic Information

As a condition for confirmation of your registration, it is required to pay a 55 EUR per day of training fee on our ComAp account, at least 6 weeks prior to the scheduled date of the training course. More information you will find in the email after your registration.

We are ready to help you with booking a hotel and obtaining a visa. For more information about our corporate rates in nearby hotels and hotel booking please contact us. You can also check the List of countries with visa requirements.

Training

Arrival in Prague

Our hands-on training takes place at our modern training facility in our Prague headquarters.

Day 1

9:00 - 12:00 Single genset applications & controllers overview
ComAp technical support and website introduction, general overview of applications, documentation, controllers and possibilities of extending their functionality.

12:00 - 12:45 Lunch

12:45 - 16:00 Configuration
PC tools overview: InteliConfig, WinScope. Controller software manamgement - Firmware, Archive. Hands-on training focused on the controller configuration using single genset simulators.
Introduction of the PLC editor its basic functions.

Day 2

9:00 - 12:15 Communication
Internal and external communication modules, supported communication protocols. AirGate, WebServer, ECU. Hands-on training on MODBUS RTU/TCP, CM-Ethernet module.

12:15 - 13:00 Lunch

13:00 - 16:30 Commissioning & WebSupervisor
Commissioning and its important steps, checks before engine start, first start conditions (using Winscope), breakers control and change over, functionality and protection tests.
Websupervisor introduction - account creation, unit registration, remote monitoring and control, data logging, user management.

16:30 - 17:00 Test, Feedback