9:00 - 12:00 Single genset applications & controllers overview
ComAp technical support and website introduction, general overview of applications, documentation, controllers and possibilities of extending their functionality.
12:00 - 12:45 Lunch
12:45 - 16:00 Configuration
PC tools overview: InteliConfig, WinScope. Controller software manamgement - Firmware, Archive. Hands-on training focused on the controller configuration using single genset simulators.
Introduction of the PLC editor its basic functions.
9:00 - 12:15 Communication
Internal and external communication modules, supported communication protocols. AirGate, WebServer, ECU. Hands-on training on MODBUS RTU/TCP, CM-Ethernet module.
12:15 - 13:00 Lunch
13:00 - 16:30 Commissioning & WebSupervisor
Commissioning and its important steps, checks before engine start, first start conditions (using Winscope), breakers control and change over, functionality and protection tests.
Websupervisor introduction - account creation, unit registration, remote monitoring and control, data logging, user management.
16:30 - 17:00 Test, Feedback