1. Introduction – what is the aim of the training, etc
Block 1
2. Preheating of gas engine
3. Prelubrication of gas engines
4. Gas train
- Gas leakage test
- Minimum gas pressure
5. Cranking – Ignition, Speed governor control
6. Synchronisation specifics
Block 2
7. AFR control – how to adjust the AFR, how to commission AFR on gas gen-set
Block 3
8. How to commission ECON-4 speed governor
9. How to commission I-Step (stepper motor controller) for mixers
10. What products we can interface to – list of devices, how these devices can be configured
Block 4
11. Possible issue during commissioning
- Gas quality
- Engine does not start
- Engine is not stable
- Engine does not reach requested kWs
- Cylinder temperatures are too high
Block 5
12. Questions, whatever was not discussed